Minimum consignment of goods: pcs
Multiplicity of a consignment of goods: pcs
Select the quantity corresponding to the minimum batch or
←
CCD MKO-P1-M/A-10SC Terminal Closure Kit
Part number:
130408-00143
Copyed at buffer
About this item (PDF)
Significant cost savings may be achieved if you order a closure complete with UPMK-Panda - item number 130408-00216..
The coupling is designed for jointing an overhead trunk cable with subscriber drop cables of small diameter. The main feature of MKO closures marked "A" is a patch panel for SC type adapters inside. This allows installer to use preterminated subscriber drop cables and provide multiple reconnections..
The closure is a small-sized sealed rectangular container. A removable organizer plate is installed inside the container.On the back side there are 2 splice inserts for placing fiber splices protected by KDZS 4525 sleeves/ On the front side of the organizer plate there are slots for installing SC adapters. Also on the front side of the organizer plate there is an splitter insert L2-SP type is located. It can accommodate one splitter in mini-case PO-1х8 -PLC -SM/0.9 -1.0 m-SC/APC or two PO-1x4 -PLC -SM/0.9 -1.0 m-SC/APC splitters, terminated with connectors SC..
Cover and body are tightened together- using 2 plastic latches on steel spring loaded hinges..
Elastic gel is around the closure body, in the places of contact with the cover. Elastic gel is used to seal the case, and to seal the inserted trunk and subscriber cables..
Despite its small dimensions, the design of the closure ensures to route the transit loop of the buffer tubes without cutting..
The design of the closure provides:
• introduction and fastening of 2 cables with an outer jacket up to 14 mm in diameter;
• the possibility of organizing a “transit” input of 1 cable
• placement of up to 36 fiber fusion splices (KDZS 4525) of distribution cables and 10 splices of drop cables;
• installation of 2 PLC splitters with a nominal size of body 60х7х4 mm;
• installation of up to 10 ODF adapters of SC type;
• enter 10 drop cables of a round profile with a diameter of 2-3 mm or a rectangular profile of the "butterfly" type (FRP style cable)..
If it is necessary to install closure on poles or walls, it is recommended to acquire a appropriate mounting bracket. The design of the bracket allows to remove the closure from the pole and hang it back without using special tools and consumables such as mounting tape..
Please note that the Technical specifications list the operating temperature range of terminal closure without the characteristics of the installed components: adapters, pigtails, and splitters. When using closure with the specified components, the operating temperature range may be limited by the parameters of the installed products.