Minimum consignment of goods: pcs
Multiplicity of a consignment of goods: pcs
Select the quantity corresponding to the minimum batch or
←
CCD MOG-UM-44-1K4845 Closure Kit (Clamp, 4 + 4 ports)
Part number:
130101-00092
Copyed at buffer
About this item (PDF)
The MOG-UM-44 Closure Kit is used for communication duct cables of any design including corrugated steel tape armored cables. It is a modern version of the MOG-U Closure Kit distinguished by the method of the closure head sealing. The Closure is used in tight cable duct manholes, nonstandard manholes, and locations where the distance between the cable support brackets is less than 700 mm..
Rubber O-ring gaskets and reinforced plastic clamps equipped with a self-tightening lock are used for sealing.
It is important to consider that closure is distinguished by different types of the heads used: 2, 3 and 4 heat shrink types on one side of the MOG and the head with 4 cylindrical ports on the other side as it is in the MOG-T-3 closure. The closure body installation in relation to the head is highly important, because the heads have different diameters. An extra securing plastic ins ert is installed to seal the closure body on the side of the head without the flange.
The incoming cables are sealed with heat shrink tubes (HST). Initially all round cable ports on the closure head are blocked and have a gradient shape with different diameters. Cutting off the branch pipe in a certain place, you can choose the hole size as close as possible to the cable diameter. This eliminates an excessive stretching of the HST tubes after shrinkage when inserting rather thin cables. Anchor nodes for cable central strength members are installed on the closure tray.
The splice tray K48-4525 for 48 sleeves is basic for the MOG-U closure. This tray makes possible to splice cables with different numbers of fibers in the buffer tubes. Thanks to this the entering of buffer tubes with any number of fibers in to the entire splice tray without adapters is allowed.
It is recommended to purchase extra KSO-2 or KSO-3 Support Brackets to install the closure in tight manholes. The support bracket is installed on the manhole wall above the bracket level to ensure that the closure is placed in the gap between the bracket top and the manhole ceiling. In this case, the cable excess coils are placed in the manhole corners.
130102-00025
20/04/2024
130102-00418
20/04/2024
